Table of Contents
Advertisement
[NetWare]
Port Status
TransportProtocol
Print Mode
PJL
138
5 Control Panel Settings
Network/Port
NetWare
Setting
Sets whether to enable or disable the NetWare port at printer start-up.
• [Enabled]
• [Disabled] (default)
Important
• If the printer runs out of memory when the port is enabled, the port is sometimes
automatically disabled. If this happens, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Sets the protocol of the transport layer used by NetWare. Either or both of IPX/SPX
and TCP/IP can be selected.
• [TCP/IP, IPX/SPX] (default)
• [TCP/IP]
• [IPX/SPX]
Note
• When using TCP/IP protocol, both the printer and client computers must have IP
addresses.
Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly. (See *1 on P. 202.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
• [HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). (See *3 on P. 202.)
Sets whether to enable or disable PJL commands that are sent from the computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for the
next job while another language emulation is being processed by the printer. (See
*5 on P. 202.)
• [Enabled] (default)
• [Disabled]
NetWare
Port Status
NetWare
TransportProtocol
NetWare
Print Mode
NetWare
PJL
NetWare
No. of searches
NetWare
TBCP Filter
Description
Advertisement
Table of Contents
