Table of Contents
Advertisement
Right side and rear views of the printer
No.
Name
1
Top left cover D
2
Upper left cover A
3
Duplex module cover B
4
Bottom left cover C
5
Adjusting foot
6
RESET button
7
Gigabit Ethernet interface
connector (optional)
8
10BASE-T/100BASE-TX
connector
9
USB 2.0 connector
38
2 Basic Operation
7
8
9
6
5
Open this cover to remove jammed papers.
Open this cover to remove jammed papers.
Note
• Before you open this cover, exit the Sleep Mode and then switch off the printer.
Open this cover to remove jammed papers.
Open this cover to remove jammed papers. When Tray 6 is installed, open this cover
after moving Tray 6 to the left.
Prevents the printer from toppling over. Move the printer to its installation site and
then rotate this adjuster in clockwise direction until it touches a floor.
Automatically switches the printer off when a current leakage is detected.
Installing a Gigabit Ethernet Board Kit (optional) allows the connection of a
1000BASE-T Ethernet interface cable.
Connects to a 10BASE-T/100BASE-TX Ethernet interface cable.
Note
• Installing a Gigabit Ethernet Board Kit (optional) does not allow the use of
Ethernet connector in the standard configuration.
Connects to a USB 2.0 cable.
Description
1
2
3
4
Advertisement
Table of Contents
