Changing The Paper Type Settings Of Trays - Fuji Xerox DocuPrint C5155d User Manual

Important
• You can specify a value up to 420 mm for the length (Y) when the width (X) is 297 mm, while a value up to 432
mm can be specified for the length (Y) when the width (X) is 279 mm.

Changing the Paper Type Settings of Trays

If the paper type setting does not match the actual type of the paper, toner may not fuse
properly to the paper, resulting in poor print quality.
Use the procedure below to change the paper type settings of trays.
Important
• If a paper type setting results in toner not fusing properly on the paper and poor print quality, try changing to
a different paper type setting and printing again. If the paper type setting is for plain paper, for example, try
changing it to bond paper or recycled paper.
Note
• Refer to "Supported Paper Type" (P. 102) for information about setting values appropriate for each paper type.
1. On the control panel, press the <Settings>
button to display the menu screen.
2. Press the < > button until [Admin Menu] is
displayed.
3. Press the < > or <OK> button to select.
[Network/Port] is displayed.
4. Press the < > button until [Printer Settings] is
displayed.
5. Press the < > or <OK> button to select.
[Substitute Tray] is displayed.
6. Press the < > button until [Paper Type] is
displayed.
7. Press the < > or <OK> button to select.
[Tray 1] is displayed.
8. Press the < > button until the desired paper
tray is displayed, and then press the < >
button to display its current setting.
The current set value is displayed.
9. Press the < > button until the desired paper
type is displayed.
(Example: Bond)
120
4 Paper
Settings
LanguageEmulation
Settings
Admin Menu
Admin Menu
Network/Port
Admin Menu
Printer Settings
Printer Settings
Substitute Tray
Printer Settings
Paper Type
Paper Type
Tray 1
Tray 1
•Plain
Tray 1
Bond