Table of Contents
Advertisement
• When the optional finisher is installed
Note
• The [Please wait...] message indicates that the machine is warming up. The printer is not available during
warming up.
• Refer to " Error Messages (in Alphabetical Order)" (P. 246) when the error message is displayed.
• If the printer does not power on, check the following:
• The power cord is plugged in.
• The main power is switched on.
• The <RESET> button is in the depressed position.
Switching the Power Off
Important
• Do not switch the power off when the display reads [Please wait...] on the control panel.
• Do not switch the power off during printing. Doing so can cause paper jams.
• Switching off the power may erase any print data that remains in the printer or information stored in the
memory of the printer.
• Power off processing is performed internally on the printer for a while after the power is switched off (<Energy
Saver> button blinks). Make sure the <Energy Saver> button is completely turned off before switching on the
printer again.
1.
Make sure that the printer is not in process by
checking lamps or the display on the control
panel.
2.
Press the <
switch to turn off the power.
• When the optional finisher is installed
> side of the printer's power
2.2 Switching On/Off the Power
47
Advertisement
Table of Contents
