Fuji Xerox DocuPrint C5155d User Manual page 371

11. Press the <OK> button.
The screen to enter the number of print is
displayed.
12. Press the < > button to specify the number
of prints, and then press the < > or <OK>
button to select. The print starting screen is
displayed.
13. Press the <OK> button.
The print job starts.
14. The [ ] (black square mark) will be printed on
the output chart (one square for face side, two
squares for the back side).
Place the chart so that the square is located
on the left bottom of the chart, and calculate
the required amount of correction to set the
vertical and horizontal lines printed on the
chart 10 mm off from the paper edge.
Check the printed data to fix the final
position.
15. Press the < > button until [Adjust Side 1] is
displayed.
16. Press the < > or <OK> button to select.
[Adjust Lead Regi] is displayed.
17. Press the < > or <OK> button to select.
Actual adjusted value in the vertical direction
(Lead Regi) is displayed.
18. Specify the value calculated in the step 14,
press the <OK> button. Set the plus (+) value
for moving the print image downward, the
minus (-) value for moving the print image
upward.
19. Press the < > or <OK> button to return to the
step 8 and repeat the same procedures for
adjusting the Side Regi.
20. Press the < > button until [Adjust Side Regi]
is displayed.
21. Press the < > or <OK> button to select.
Actual adjusted value in the horizontal
direction (Side Regi) is displayed.
22. Specify the value calculated in the step 14,
press the <OK> button. Set the plus (+) value
for moving the print image leftward, the
minus (-) value for moving the print image
rightward.
PrintChart-1Sided
1Set(s)
Press OK to
Print Chart
Press OK to
Print Chart
Lead Regi
Side Regi
Tray 2
Adjust Side 1
Adjust Side 1
Adjust Lead Regi
Adjust Lead Regi
•0.0mm
Adjust Lead Regi
•0.0mm
Adjust Side 1
Adjust Lead Regi
Adjust Side 1
Adjust Side Regi
Adjust Side Regi
•0.0mm
Adjust Side Regi
•0.0mm
7.14 Adjusting the Paper Regi
371