Emptying The Punch Waste Container; Emptying The Hole Punch Waste Container (For Finisher B1) - Fuji Xerox ApeosPort-VI C7771 Quick Reference

Emptying the Punch Waste Container

Emptying the Hole Punch Waste Container (for Finisher B1)

When the Finisher B1 (optional) is installed and the hole punch waste container becomes
full, a message appears on the touch screen. When the message appears, empty the hole
punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container while the
1
Make sure that the machine is not operating,
and open the front cover.
2
Lift the top transport cover, and then open the
front transport cover of the finisher.
3
Pull out the hole punch waste container.
machine is off, the machine does not recognize that the container has been emptied.
• When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power
Saver> button on the control panel before you empty the hole punch waste container.
• When emptying the punch waste container, press the <Machine Status> button and check the
current status for the hole punch waste container even when the control panel is lit.
Emptying the Punch Waste Container
5
103