Fuji Xerox DocuPrint C5155d User Manual page 194

[Allocate Memory]
[Allocate Memory] changes the size of memory and form memory of each interface.
Important
• Memory is reset when its size is changed, and all data stored in each of the memory areas is deleted.
• You cannot allocate more than the total memory. When the memory allocation settings exceed the size of
mounted memory when the power is turned on, the system automatically adjusts memory allocation.
• If the printer runs out of memory when ports are set to be enabled at printer startup, the ports are sometimes
automatically disabled. If this happens, either disable unused ports, or change the memory allocation under
[Allocate Memory]. Note, however, that the USB ports are never automatically disabled.
Note
• Memory allocation, excluding the print page buffer, can be set on the control panel or in CentreWare Internet
Services.
• The print page buffer is the area where the actual printed image is plotted. The size of the print page buffer
can be changed directly by the user. Area remaining after memory is allocated for other uses is allocated as the
print page buffer.
When printing high-resolution documents, set so that a large buffer size is allocated as print page buffer.
The actual size of the allocated print buffer can be confirmed by printing the [Configuration Report]. You can
also check it by using CentreWare Internet Services.
PS
HPGL Auto Layout
Job Ticket Memory
194
5 Control Panel Settings
(See *2 on P. 202.)
Admin Menu
Allocate Memory
Setting
Specifies the size of memory used by PostScript.
Specify memory size from 70.00 to 128.00 MB in 0.25 MB increments. The
maximum size that can be set changes according to the amount of free
memory.
• [70.00 M] (default)
Specifies the size of memory to be used in HP-GL and HP-GL/2 auto layout.
Specify memory size from 64 to 5120 KB in 32 KB increments. The
maximum size that can be set changes according to the amount of free
memory.
• [64K] (default)
When HDD Extension Kit (optional) is installed, the hard disk is used for
auto layout memory. In this case, the size cannot be changed by the
user, and is displayed as [Hard Disk] on the display.
Specify the amount of memory to use for job tickets from 0.25 to 8.00 MB
in 0.25 MB increments.
The maximum amount of memory you can allocate varies according to
the amount of free space available in memory.
• [0.25 MB] (default)
Allocate Memory
PS
Allocate Memory
HPGL Auto Layout
Allocate Memory
Job Ticket Memory
Allocate Memory
Receiving Buffer
Description