Clocks - Measurement Computing Data Translation DT3034 User Manual

Clocks

Internal Clock Support
SupportsInternalClock
External Clock Support
SupportsExternalClock
Simultaneous Input/Output on a Single
Clock Signal
SupportsSimultaneousClocking
Base Clock Frequency
BaseClockFrequency
Maximum Clock Divider
MaxExtClockDivider
Minimum Clock Divider
MinExtClockDivider
Maximum Frequency
MaxFrequency
Minimum Frequency
MinFrequency
a. Three conditions are possible:
• 200 kHz per DAC with full-scale steps in continuously-paced or waveform generation mode.
• 500 kHz per DAC with 100 mV steps in waveform generation mode.
• 500 kHz per DAC with 100 mV steps in continuously-paced mode (system-dependent).
b. If using cascaded timers, this value is 5 MHz.
c. Any two adjacent counter/timers, such as (1,2) or (2,3) or (3,4), can be cascaded in software.
If not using cascaded timers, this value is approximately 305.18 Hz.
Table 20: DT3034 Clock Options
DT3034 A/D
Yes
Yes
20 MHz 20 MHz 0
1.0
1.0
500
kHz
1.2 Hz
D/A DIN DOUT
Yes Yes
Yes Yes
0 20 MHz 0
1.0 1.0 1.0 65536
1.0 1.0 1.0 2.0
500 10
a
kHz 0 0 MHz
0.005
1.2 Hz 0 0 Hz
Supported Device Driver Capabilities
C/T QUAD
0
0
b
0
c
0
119