Supported Software - Measurement Computing Data Translation DT3034 User Manual

Chapter 1

Supported Software

The following software is available for use with the DT3034 boards and on the Data
Acquisition OMNI CD:
• DT3034 Device Driver – The device driver is installed automatically when you install the
• The Quick DataAcq application – This application provides a quick way to get a DT3034
• The quickDAQ application – An evaluation version of this .NET application is included
• DT3034 Calibration Utility – The DT3034 Calibration Utility allows you to calibrate the
• Measure Foundry –An evaluation version of this software is included on the Data
• DT-Open Layers for .NET Class Library – Use this class library if you want to use Visual
• DataAcq SDK – Use the Data Acq SDK if you want to use Visual Studio 6.0 and Microsoft
• DTx-EZ – DTx-EZ provides ActiveX controls, which allow you to access the capabilities of
• DAQ Adaptor for MATLAB – Data Translation's DAQ Adaptor provides an interface
• LV-Link – An evaluation version of LV-Link is included on the Data Acquisition OMNI
Refer to the Data Translation web site (www.mccdaq.com) for more information on the
appropriate software package for your application.
18
software from the Data Acquisition OMNI CD. You need the device driver to use the
DT3034 board with any of the supported software packages or utilities.
board up and running. Using the Quick DataAcq application, you can verify the features
of the board, display data on the screen, and save data to disk.
on the Data Acquisition OMNI CD. quickDAQ lets you acquire analog data from all
devices supported by DT-Open Layers for .NET software at high speed, plot it during
acquisition, analyze it, and/or save it to disk for later analysis.
analog input and analog output subsystems of the DT3034 board. Refer to
more information on this utility.
Acquisition OMNI CD. Measure Foundry is drag-and-drop test and measurement
application builder designed to give you top performance with ease-of-use development.
Order the full development version of this software package to develop your own
application using real hardware.
C# or Visual Basic for .NET to develop your own application software for a DT3034 board
using Visual Studio 2003 or Visual Studio 2005; the class library complies with the
DT-Open Layers standard.
C or C++ to develop your own application software for a DT3034 board using Windows
XP, Windows Vista, or Windows 7; the DataAcq SDK complies with the DT-Open Layers
standard.
the DT3034 board using Microsoft Visual Basic or Visual C++; DTx-EZ complies with the
DT-Open Layers standard.
between the MATLAB Data Acquisition (DAQ) subsystem from The MathWorks and
Data Translation's DT-Open Layers architecture.
CD. Use LV-Link if you want to use the LabVIEW graphical programming language to
access the capabilities of the DT3034 boards.
page 123 for