Analog Input Conversion Modes; Continuously-Paced Scan Mode - Measurement Computing Data Translation DT3034 User Manual

Chapter 6

Analog Input Conversion Modes

DT3034 boards support the following conversion modes:
• Single-value operations are the simplest to use but offer the least flexibility and
• Scan mode takes full advantage of the capabilities of the DT3034 board. In a scan, you can

Continuously-Paced Scan Mode

Use continuously-paced scan mode if you want to accurately control the period between
conversions of individual channels in a scan.
When it detects an initial trigger, the board cycles through the channel list, acquiring and
converting the value for each entry in the channel list; this process is defined as the scan. The
board then wraps to the start of the channel list and repeats the process continuously until
either the allocated buffers are filled or you stop the operation. Refer to
information on buffers.
The conversion rate is determined by the frequency of the A/D sample clock; refer to
for more information on the A/D sample clock. The sample rate, which is the rate at which a
single entry in the channel list is sampled, is determined by the frequency of the A/D sample
clock divided by the number of entries in the channel list.
To select continuously-paced scan mode, use software to specify the dataflow as Continuous,
ContinuousPreTrigger, or Continuous PrePostTrigger; refer to
about these trigger acquisition modes.
The initial trigger source depends on the trigger acquisition mode selected; refer to
more information on the supported trigger acquisition modes and trigger sources.
76
efficiency. Use software to specify the range, gain, and analog input channel (among other
parameters); acquire the data from that channel; and convert the result. The data is
returned immediately. For a single-value operation, you cannot specify a clock source,
trigger source, trigger acquisition mode, scan mode, or buffer.
Single-value operations stop automatically when finished; you cannot stop a single-value
operation.
specify a channel list, clock source, trigger source, trigger acquisition mode, scan mode,
and buffer. Two scan modes are supported: continuously-paced scan mode and triggered
scan mode (often called burst mode). These modes are described in the following
subsections.
Using software, you can stop a scan mode operation by performing either an orderly stop
or an abrupt stop. In an orderly stop, the board finishes acquiring the specified number of
samples, stops all subsequent acquisition, and transfers the acquired data to host memory;
all subsequent triggers or retriggers are ignored. In an abrupt stop, the board stops
acquiring samples immediately; the acquired data is not transferred to host memory, but
all subsequent triggers or retriggers are ignored.
page 85 for more
page 74
page 81 for more information
page 79 for