Measurement Computing Data Translation DT3034 User Manual page 138

Symptom
Computer does not Board is not seated properly.
boot.
The power supply of the
computer is too small to handle
all the system resources.
System lockup. Board is not seated properly.
Table 22: Troubleshooting Problems (cont.)
Possible Cause Possible Solution
Check that the slot in which your DT3034 board is
located is a PCI slot, that the board is correctly
seated in the slot, and that the board is secured in the
slot with a screw.
Check the power requirements of your system
resources and, if needed, get a larger power supply;
consult the board's specifications on
manual.
Check that the slot in which your DT3034 board is
located is a PCI slot, that the board is correctly
seated in the slot, and that the board is secured in the
slot with a screw.
Troubleshooting
page 149 of this
137