Loading The Device Driver; Windows Xp - Measurement Computing Data Translation DT3034 User Manual

Chapter 2

Loading the Device Driver

To load the DT3034 device driver in:
• Windows XP, follow the steps on
• Windows Vista, follow the steps on
• Windows 7, follow the steps on

Windows XP

Once you have installed the software from the Data Acquisition OMNI CD, installed a DT3034
board, and powered up the host computer, the New Hardware Found dialog box appears. Do
the following to load the device driver in Windows XP:
1. Click Next.
2. Click Search for a suitable driver for my device (recommended).
3. Click Specify a location, and click Next.
4. Browse to Windows\Inf\DT3034.Inf, and then click Open.
5. Click OK.
6. Click Next.
7. Click Finish.
8. Open the Control Panel.
9. Double-click the Open Layers Control Panel icon.
10. Select the DT3034 board to configure, and then click Advanced.
11. If you are using an Optiplex computer or experience timing problems with your DT3034
12. When you are finished, click Close.
Once you have finished loading the device driver, perform the steps in
page 33
30
The files are copied.
By default, the prompt "Handles Overloaded Bus?" is checked.
board, uncheck this box.
to attach and configure the screw terminal panel.
page 30.
page 31.
page 31.
Chapter 3 starting on