Checking Readiness For Operation; Before Each Use; Checking Height Adjustment - Dräger 8000 IC Operating Instructions Manual

Before each use

Checking height adjustment

Checking Readiness for Operation

Before using incubator for the first time
Verify that line voltage corresponds to the
specification on the rating plate. Check under section
Technical Data for supply voltage range.
Before each use
Verify that equipment has been disinfected.
Check that adequate gas supply is available for all
equipment to be used.
Check that all accessories and therapy equipment
required are available and in good condition.
Check readiness for operation of accessories
according to their respective Operating Instructions.
Check that the incubator hood has no cracks or
sharp, chipped edges.
Check that hinges and pivots on the hood are in
proper working order. Especially check the front door
hinges and all port hole doors for proper function.
Check that all cables and hoses are routed correctly
and securely.
Connect to line power.
WARNING !
This device is to be used only in rooms with
line power installations complying with nation-
al safety standards for hospital patient rooms.
(e.g., IEC 601.1, "Safety of Medical
Equipment).
To maintain grounding integrity, connect only
to a "hospital grade" receptacle. Always
disconnect supply before servicing.
Checking height adjustment
1 Press right foot pedal – incubator is raised.
2 Press left foot pedal – incubator is lowered.
Adjust to a convinient working height.
Checking Readiness for
Operation
2 1
34