Thermo Monitoring, Optional - Dräger 8000 IC Operating Instructions Manual

Operation
Thermo Monitoring with ThermoView
Necessary for Thermo Monitoring:
– Second receptacle for peripherial skin temperature
sensor, white plug!
– Optional BabyLink interface board with ThermoView
Software and BabyLink Interface cable
– Personal computer, see specifications in ThermoView
Operators Manual, or
– Interface to patient monitor system, please contact the
manufacturer of your patient monitor for information.
1 Connect peripheral skin temperature sensor to the
lower socket on the left side of the incubator base.
2 Route the cable through one of the U gromments in
the hood.
3 Remove protection foil from the sensor.
Place sensor securly on extremities of the patient, pre-
fereable on the foot.
– Secure the sensor cable with a adhesive strip.
– Connect the PC with the MediCable to the seriell in-
terface port of the BabyLink board in the incubator.
Follow instruction for Use for the BabyLink.
Display Peripherical Skin Temperature on
Incubator without ThermoView
4 Press © button continuously for a maximum time of
30 seconds. The yellow LED on the button lights.
5 The peripherical skin temperaure is displayed as long
as the button is pressed.
4 Stop pressing the © button.
– The yellow LED on the button © shuts off and
5 the skin temperature measured by the primary sensor
will be displayed again.
NOTE: The measurement of the peripherical temperatu-
re does not affect the temperature control of the
incubator. Both skin temperatures (tummy and
toe) can be monitored when the incubator is
operated in air mode.
52
Display Peripherical Skin
2
3
°C HAUT/SKIN/PEAU/PIEL °C LUFT/AIR
°C °C
5
4
°C
Check
Control
36 °C
±0,1
Thermo Monitoring
Temperature
1
°C
>37 °C
Reset Check
Control