Adjust Working Height; Open Rear Panel - Dräger 8000 IC Operating Instructions Manual

Preparation

Adjust Working Height

connect with mains power
1 push down right foot pedal – incubator will drive up
2 push down left foot pedal – incubator will drive down
WARNING !
This device is to be used only in rooms with
line power installations complying with nation-
al safety standards for hospital patient rooms.
(e.g., IEC 601.1, "Safety of Medical
Equipment).
To maintain grounding integrity, connect only
to a "hospital grade" receptacle. Always dis-
connect supply before servicing.
WARNING !
Keep space above the incubator clear of
obstruction!
Nothing must be kept below the stroge cabi-
nets. Hoses, circuits, and cables must be long
enough for the height of the incubator being
adjusted. They must be routed in a way that
no kinking, disconnection or squeezing can
occure.
Open Rear Panel (if installed)
Open and lower incubator rear panel
in order to:
change water bottles
change air filter
connect sensor module connector
close rear panel
26
Adjust Working Height

Open Rear Panel

2 1