Dräger 8000 IC Operating Instructions Manual page 51

Hide thumbs Also See for 8000 IC:
Table of Contents

Advertisement

Alarms
Alarms
In case of deviations greater or equal than ±1.0 °C
between set and measured value of skin temperature:
1 Red LED Alarm and
2 Red LED ±1.0 °C flashing,
3 display flashing accompanied by intermittent audible
alarm.
The audible alarm can be silenced for 10 minutes:
4 Press G button.
g
5 Yellow LED
lights up.
When measured value is again within less ±1.0 °C of the
set value:
LED ±1.0 °C and
1 LED Alarm goes out, audible alarm stops.
g
5 Yellow LED
goes out.
If the sensor plug is disconnected or sensor is defective:
6 Display of 3 dashes in center of display.
After 15 seconds:
intermitted audible alarm starts
6 Display of 3 flashing dashes in center of display.
7 Red LED Alarm flashing.
8 Red LED Sensor flashing.
In this case:
Connect sensor without delay or replace sensor.
The audible alarm can be silenced for 10 minutes:
9 Press G button.
g
10 Yellow LED
lights up.
8 Red LED Alarm lights up.
°C HAUT/SKIN/PEAU/PIEL
°C LUFT/AIR
°C
°C
3
°C
2
Check
Control
36 °C
±0,1
°C HAUT/SKIN/PEAU/PIEL
°C LUFT/AIR
°C
°C
6
°C
Check
36 °C
Control
8
±0,1
Operation
1
5
°C
4
>37 °C
Check
Reset
Control
7
10
°C
9
>37 °C
Reset
Check
Control
51

Advertisement

Table of Contents
loading

Table of Contents