Table of Contents
Advertisement
Step 27: Café Table Assembly
Part 1
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
A: Attach 1 (1926) Table Support to the inside of each (1500) Post on the Cafe Wall side through the middle
hole using 1 (LS3) 1/4 x 3" Lag Screw (with flat washer) per board. The distance from ground to the middle hole
should measure 18". (fig. 27.1)
B: Make sure both (1926) Table Supports are level then attach to the posts in the remaining holes with 2 (LS3)
1/4 x 3" Lag Screws (with flat washers) per support. (fig. 27.1)
Fig. 27.1
18"
Wood Parts
2 x
Table Support 2 x 6 x 12-5/16"
1926
1926
1926
LS3
x 6
with flat
washer
6 x
LS3
Hardware
1/4" x 3" Lag Screw
(with flat washer)
47
europecustomerservice@kidkraft.com
Advertisement
Table of Contents
