Huawei Quidway S2700 Series Configuration Manual page 123

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
Networking Requirements
As shown in
the FTP server are directly connected and on the same network segment. The Switch has a
reachable route to the FTP server.
The Switch acts as the FTP client. Interfaces ranging from Ethernet0/0/1 to Ethernet0/0/4 can
be used to set up FTP connections and they share the IP address 10.1.1.1.
The Switch downloads files from the FTP server.
Figure 8-3 Networking diagram of the Switch functioning as the FTP client
PC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Enable FTP on the remote FTP server. Add an FTP user named u1 and set the password to
ftppwd.
Step 2 Create VLAN 10 on the Switch and assign the IP address 10.1.1.1 to VLANIF10.
<Quidway> system-view
[Quidway] vlan 10
[Quidway-vlan10] quit
[Quidway] interface ethernet 0/0/1
[Quidway-Ethernet0/0/1] port hybrid pvid vlan 10
[Quidway-Ethernet0/0/1] port hybrid untagged vlan 10
[Quidway-Ethernet0/0/1] quit
[Quidway] interface ethernet 0/0/2
[Quidway-Ethernet0/0/2] port hybrid pvid vlan 10
[Quidway-Ethernet0/0/2] port hybrid untagged vlan 10
[Quidway-Ethernet0/0/2] quit
[Quidway] interface ethernet 0/0/3
[Quidway-Ethernet0/0/3] port hybrid pvid vlan 10
Issue 01 (2011-07-15)
Figure 8-3, the remote server at 10.1.1.2 serves as the FTP server. The Switch and
FTP session
configuration
cable
FTP Client
Log in to the FTP server from the FTP client.
Download files from the server to the storage device of the client.
IP address of the FTP server
Name of the destination file and position where the destination files are located on the
Switch
Name of the FTP user set as u1 and the password set as ftppwd on the client
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
FTP Server
8 FTP and TFTP
112