Huawei Quidway S2700 Series Configuration Manual page 165

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
Networking Requirements
When you need to log in from a switch to other switches to configure the switches, you can
configure the switch as an STelnet client.
As shown in
client can log in to the SSH server in the authentication mode of password, RSA, password-rsa,
or all.
The following login users need to be configured.
l
l
The user interface supports only the SSH protocol.
Figure 9-5 Networking diagram of connecting the STelnet client and the SSH server
10.164.39.220/24
Switch
SSH server
Client001
Client002
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
Issue 01 (2011-07-15)
Figure 9-5, after the STelnet service is enabled on the SSH server, the STelnet
Client001, with the password as huawei and the authentication mode as password
Client002, with the password as rsakey001 and the authentication mode as RSA
SSH Server
10.164.39.222/24
Client001
Interface
Ethernet0/0/1
Ethernet0/0/1
Ethernet0/0/1
Create a VLAN that each interface belongs to and assign an IP address to each VLANIF
interface.
Configure Client001 and Client002 on the SSH server.
Create a local key pair on the STelnet client and SSH server separately.
Generate an RSA public key on the SSH server and bind the RSA public key of the SSH
client to Client002.
Enable the STelnet service on the SSH server.
Client001 and Client002 log in to the SSH server through STelnet.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10.164.39.221/24
Client002
9 Telnet and SSH
VLANIF interface IP address
VLANIF 10 10.164.39.222/24
VLANIF 10 10.164.39.220/24
VLANIF 10 10.164.39.221/24
154