Huawei Quidway S2700 Series Configuration Manual page 162

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
The IP address of the SSH server is 192.168.1.1.
The user interface supports only SSH.
Figure 9-4 Networking diagram of configuring the PC as the STelnet client to connect to the
SSH server
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Generate a local key pair on the server.
<Quidway> system-view
[Quidway] sysname SSH Server
[SSH Server] rsa local-key-pair create
The key name will be: Quidway_Host
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
Input the bits in the modulus[default = 512]: 768
Generating keys...
.......++++++++++++
..........++++++++++++
...................................++++++++
......++++++++
Step 2 Configure the VTY user interface.
[SSH Server] user-interface vty 0 4
[SSH Server-ui-vty0-4] authentication-mode aaa
[SSH Server-ui-vty0-4] protocol inbound ssh
[SSH Server-ui-vty0-4] quit
Issue 01 (2011-07-15)
SSH Client
Configure Client001 on the SSH server.
Enable STelnet service on the SSH server.
Configure password authentication as the default authentication mode on the SSH server.
Name and the authentication mode of the SSH user
Password of the SSH user
Name of the SSH server
It will take a few minutes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IP Network
SSH Server
9 Telnet and SSH
151