Enabling The Telnet Service - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
Applicable Environment
To remotely log in to the switch through the Telnet protocol for maintenance and management,
you need to configure Telnet terminal services.
Pre-configuration Tasks
Before configuring Telnet terminal services, complete the following tasks:
l
l
l
l
Data Preparation
To configure Telnet terminal services, you need the following data.
No.
1
3
4
5
6

9.2.2 Enabling the Telnet Service

Before establishing a Telnet connection with the server, you need to enable the Telnet service.
Context
Do as follows on the switch that serves as an Telnet server.
Select and perform one of the following two steps for IPv4 or IPv6.
Procedure
l
Issue 01 (2011-07-15)
Ensuring that the switch runs normally
Ensuring that the IP addresses of interfaces on the switch are configured correctly
Configuring the user account, correct login authentication mode, and call-in and call-out
restriction
Ensuring that reachable routes exist between the terminal and the switch
Data
IP address of the switch
IPv4/IPv6 address or host name of the remote switch
Number of the TCP port that is used by the remote switch to provide Telnet services
(Optional) Timeout period after which the server terminates the connection with the
user interface
(Optional) Source IP address or source interface of the device functioning as an Telnet
client
For the IPv4 network
1. Run:
system-view
The system view is displayed.
2. Run:
telnet server enable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Telnet and SSH
120