Enabling The Stelnet Client - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
that the key does not exist after the peer-public-key end command is run and the system view
is displayed.
Step 6 Run:
peer-public-key end
Return to the system view from the public key view.
Step 7 Run:
ssh client servername assign rsa-key keyname
The RSA public key is assigned to the SSH server.
----End

9.5.4 Enabling the STelnet Client

You can log in to the SSH server from the SSH client through STelnet.
Context
Do as follows on the switch that serves as an SSH client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 According to the address type of the SSH server, select and run one of the following two
commands.
l For IPv4 addresses,
l For IPv6 addresses,
Issue 01 (2011-07-15)
NOTE
l Before being assigned to the SSH server, the assigned peer RSA public key must be obtained from the
SSH server and must be configured on the SSH client. Then, the STelnet client client can successfully
undergo the validity check on the RSA public key of the SSH server.
l If the RSA public key stored on the SSH client becomes invalid, run the undo ssh client servername
assign rsa-key command to cancel the association between the SSH client and the SSH server. Then,
run the ssh client servername assign rsa-key keyname command to allocate a new RSA public key to
the SSH server.
NOTE
When accessing an SSH server, the STelnet client can carry the source address and choose the key exchange
algorithm, encryption algorithm, or HMAC algorithm, and configure the keepalive function..
Run the stelnet host-ipv4 [ port ] [ [ prefer_kex { dh_group1 | dh_exchange_group } ] |
[ prefer_ctos_cipher { des | 3des | aes128 } ] | [ prefer_stoc_cipher { des | 3des |
aes128 } ] | [ prefer_ctos_hmac { sha1 | sha1_96 | md5 | md5_96 } ] |
[ prefer_stoc_hmac { sha1 | sha1_96 | md5 | md5_96 } ] ]
alivecountmax ] ] command. You can log in to the SSH server through STelnet.
Run the stelnet ipv6 host-ipv6 [ -i interface-type interface-number ] [ port ] [ [ prefer_kex
{ dh_group1 | dh_exchange_group } ] | [ prefer_ctos_cipher { des | 3des | aes128 } ] |
[ prefer_stoc_cipher { des | 3des | aes128 } ] | [ prefer_ctos_hmac { sha1 | sha1_96 |
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Telnet and SSH
*
[ -ki aliveinterval [ -kc
137