Huawei Quidway S2700 Series Configuration Manual page 166

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
l
l
l
l
Procedure
Step 1 Create a VLAN that each interface belongs to and assign an IP address to each VLANIF interface.
Create VLAN 10 on the Switch that functions as the server and assign IP address
10.164.39.222/24 to interface VLANIF10.
<Quidway> system-view
[Quidway] vlan 10
[Quidway-vlan10] quit
[Quidway] interface ethernet 0/0/1
[Quidway-Ethernet0/0/1] port hybrid pvid vlan 10
[Quidway-Ethernet0/0/1] port hybrid untagged vlan 10
[Quidway-Ethernet0/0/1] quit
[Quidway] interface vlanif 10
[Quidway-Vlanif10] ip address 10.164.39.222 24
Assigning an IP address to the Switch that functions as Client001 or Client002 is the same as
assigning an IP address to VLANIF 10, and is not mentioned here.
Step 2 Create a local key pair on the SSH server.
<Quidway> system-view
[Quidway] rsa local-key-pair create
The key name will be: Quidway_Host
The range of public key size is (512 ~ 2048).
NOTES:If the key modulus is greater than 512,
Input the bits in the modulus[default = 512]:
Generating keys...
.......++++++++++++
..........++++++++++++
...................................++++++++
......++++++++
Step 3 Create an SSH user on the server.
# Configure a VTY user interface.
[Quidway] user-interface vty 0 4
[Quidway-ui-vty0-4] authentication-mode aaa
[Quidway-ui-vty0-4] protocol inbound ssh
[Quidway-ui-vty0-4] quit
l Create an SSH user named Client001.
Issue 01 (2011-07-15)
IP addresses of the FTP server and client, as shown in
SSH user name and authentication mode
Password or RSA public key
SSH server name
It will take a few minutes.
NOTE
SSH users can be authenticated in four modes: password, RSA, password-rsa, and all.
l Before configuring the authentication mode of password or password-rsa, you must configure a local
user.
l Before configuring the authentication mode of RSA, password-rsa, or all, you must copy the RSA
public key of the SSH client to the server.
# Create an SSH user named Client001 and configure the authentication mode as
password for the user.
[Quidway] ssh user client001
[Quidway] ssh user client001 authentication-type password
# Set the password of Client001 to huawei.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Telnet and SSH
Figure 9-5
155