Huawei Quidway S2700 Series Configuration Manual page 18

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
Figure 1-1 Networking diagram of logging in through the console port
PC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the terminal communication parameters (including
baud rate, data bit, parity, stop bit, and flow control).
Procedure
Step 1 Connect the serial port of the PC (or terminal) to the console port of the switch through a standard
RS-232 cable. The local configuration environment is established.
Step 2 Run the terminal emulation program on the PC. Set the terminal communication parameters to
be 9600 bps, data bit to be 8, stop bit to be 1. Specify no parity and no flow control as shown
from
Figure 1-2 New connection
Issue 01 (2011-07-15)
Switch
Connect the PC and the switch through the console port.
Configure the login on the PC end.
Log in to the switch.
Figure 1-2 to Figure 1-4.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Logging In to Switch
7