Touchpanel As Pointing Device - Connected Directly Via Rs-232 - Crestron C2N-DVP4DI Reference Manual

Digital Video Processor
74 • Contents
Software Required
•
SIMPL Windows Version 2.03.11 or higher
•
VT Pro-e Version 3.1.1.7 or higher
•
Viewport Version 3.49 or higher
Touchpanel as Pointing Device - Connected
Directly via RS-232
NOTE: Replaces the Microsoft mouse as the pointing device.
1. Connect the RS-232 cable from the touchpanel to the C2N-DVP4DI
touchscreen mouse serial port. Use the ST-PK smart touch programming kit
and a 9 pin male to female straight through cable (pin to pin).
2. Configure the touchpanel serial port for RS-232 PORT FOR TOUCH OUT.
3. In VT Pro-e, create a page with full screen RGB window for the TPS-
5000/6000.
4. In the "Video Properties" window – select the Design tab and select Pad 1
or Pad 2.
"Video Properties" Window
In the "Project Properties" window select the Pad Area tab. Select the Pad
5.
Area 1 or Pad Area 2, and select the following:
Type: Mouse
Communications via: Serial
Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A