Setup Of The C2N-Dvp4Di Input - Crestron C2N-DVP4DI Reference Manual

Digital Video Processor
102 • Contents
Figure 7, The 16x9 Grid Displayed on a 4x3 Display Device

Setup of the C2N-DVP4DI Input

After setting up the C2N-DVP4DI with the display device, and the 16x9 grid
displays as in figure 6, you can now proceed with the calibration of the C2N-
DVP4DI inputs.
1. If your computer input is to be 16x9 RGB/video, load the PowerPoint 16x9
grid into your computer (from the examples file on the Crestron FTP site)
and enter show mode in PowerPoint.
2. From the setup menu of the C2N-DVP4DI, select the desired input source
that has the 16x9 PowerPoint (even if the source is 4x3).
3. Size and scale the display by following the directions for the RGB Video
Input adjustment in the C2N-DVP4DI Operations Guide (Doc. 6112) for
edge-to-edge adjustment.
NOTE: If the display device is set to 16x9, and the C2N-DVP4DI output is set to
16x9, then a 4x3 computer source should display the 16x9 grid correctly.
4. To see the 4x3 computer source correctly displayed, exit the C2N-DVP4DI
setup menu, return to the VT Pro-e project. If using RGB, page flip to the
4x3 RGB source. Do not use the grid; use your usual 4x3 program source
that is on that computer. The image should display correctly as a 4x3 aspect
ratio on a 16x9 display, as in figure 3. Repeat this process for 4x3 video
sources.
Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A