Crestron C2N-DVP4DI Reference Manual page 75

Crestron C2N-DVP4DI
SIMPL Windows Programming for Pointmaker
Reference Guide – DOC. 6177A
"RGB Video Properties" – Touch/Pad Area Enabled
3. Save, compile, and download the project to the C2N-DVP4DI.
4. Refer to "Device Extender Symbols for Touch Input and Output Control"
on page 61, and insert the Touch Out Format symbol.
5. In Detail View, open slot 1 of the C2N-DVP4DI and add an Analog
Initialize symbol.
6. In SIMPL Windows, program the Touch Out Format symbol, the Analog
Initialize symbol, and the C2N-DVP4DI touchpanel serial interface joins as
shown in the following diagram.
NOTE: The required serial cables are pin-to-pin RS-232 extension type, not the null
modem type. Connect COM 1 of the C2N-DVP4DI to the COM 1 port of the
Telestrator, and connect COM 2 of the C2N-DVP4DI to the COM 2 port of the
Telestrator.
NOTE: You must perform the touchscreen calibration.
Digital Video Processor
Digital Video Processor: C2N- DVP4DI • 71