Industry Compliance - Crestron C2N-DVP4DI Reference Manual

Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A
NOTE: If you extract NVRAM values to a file (Viewport, File transfer | Save
NVRAM to File), to simplify restoring them in the event of file corruption or to
distribute to identical control systems, remember that NVRAM values are position
sensitive in the program. When saving the NVRAM is crucial to your application, it is
recommended to place all symbols and/or modules that use NVRAM at the beginning
of your program. When NVRAM (.nvr file) is re-installed, all the values should line up
with the program. If the program is modified, and new logic that uses NVRAM is
placed before any older symbols using NVRAM, the previously stored values will not
line up and your presets will have to be re-entered.
NOTE: The new NVRAMDISK command (available in CUZ files later than 3.053),
will fail unless it can determine the amount of NVRAM used by the program, to ensure
that the NVRAM is not overwritten. Programs compiled in SIMPL Windows version
2.04.11 or later can provide this information. In the event of a failure of the
NVRAMDISK command, ensure that your program has been recompiled in an
appropriate version of SIMPL Windows and reloaded.
Volatile (DRAM)
NOTE: The DRAM memory runs all bit map files. To maximize loading speed of
backgrounds, keep the total page size to a maximum of 32 MB.
NOTE: To reduce the size of bit maps, make them 16 bit rather than 24 or 32 bit.
This will also reduce the load time of these files.
1. Digital, analog and serial signal values (except as noted above).
2. SIMPL+ Variables (Default if no options are specified, or if "volatile"
qualifier is used, or #DEFAULT_VOLATILE is used).
DRAM is used by the operating system for dynamic storage of variables, signals,
loading of pages and other constructs used at runtime. The actual amount of DRAM
used at any given time depends on the particular program that is running, i.e., usage
is variable, or dynamic, during normal operation.
NOTE: To check the size of the memory installed in the C2N-DVP4DI, use
Viewport and type the SHOWHW command.

Industry Compliance

As of the date of manufacture, the C2N-DVP4DI have been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Digital Video Processor
Digital Video Processor: C2N- DVP4DI • 11