Crestron C2N-DVP4DI Reference Manual page 89

Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A
2. Switch the Sympodium to Analog input as detailed in the Smart
documentation.
3. Power up the Sympodium. The Ready LED should stop flashing red, and
turn to a steady green.
4. From Viewport, type Caltouch and press enter. The C2N-DVP4DI
generates a calibration screen, displayed on the Sympodium. Perform the
calibration. This will calibrate the C2N-DVP4DI to the Sympodium.
Loading and Testing the C2N-DVP4DI/Sympodium Demo
Program
1. Using Viewport, load the program file Smart Sympodium Control from
C2N-DVP4DI Demo.spz into the C2N-DVP4DI.
2. Load the touchpanel file Smart Sympodium Control from C2N-DVP4DI
Demo.vtz into the C2N-DVP4DI.
The demo program displays two windows:
•
One composite video signal, which should be connected to input 1A
•
One DVI/RGB signal, which should be connected to DVI/RGB input 1.
If the computer is to be controlled by the Sympodium/C2N-DVP4DI, connect the
COM port on the computer to the COM 1 port on the C2N-DVP4DI.
Troubleshooting Sympodium to C2N-DVP4DI
Communications
If the Sympodium and C2N-DVP4DI are communicating properly, the LED at the
top of the Sympodium is green.
If the LED is flashing red, the two systems are not communicating properly, check
the following:
1. Verify that the correct cable is being used between the serial port on the
Sympodium, and the Touchscreen/Mouse port on the C2N-DVP4DI.
2. Verify that the C2N-DVP4DI has been configured for the correct touchout
mode.
3. Verify that the correct operating system is loaded into the C2N-DVP4DI.
Troubleshooting C2N-DVP4DI to Computer
Communications
If the C2N-DVP4DI and Smart computer are communicating properly, you will be
able to control the computer and telestrate from the VGA window displayed on the
Sympodium.
If this does not work, check the following:
1. Verify that the Smart Board software is running on the PC. You should see
the Smart toolbar on the screen.
2. Verify that the correct cable is connected from the COM port on the PC, to
the COM 1 port on the C2N-DVP4DI.
3. On the computer, you can have the Smart Board software search for a valid
Smart tablet, by going into the Control Panel menu. Select Connect, then
select Detect Smart Hardware. It should search all COM ports, and
automatically establish communications with the C2N-DVP4DI.
Digital Video Processor
Digital Video Processor: C2N- DVP4DI • 85