Crestron C2N-DVP4DI Reference Manual page 70

Digital Video Processor
66 • Contents
Assigning Mouse Packets to Serial Ports in SIMPL Windows
NOTE: The "To_Anywhere" in the example can be to a serial port on the PRO2 or
C2N-DVP4DI, a Cresnet device, an Ethernet device, etc.
Advanced users should also note that routing a signal from the Slot 1 TPS serial joins
to the COM ports on the C2N-DVP4DI appears to ensure that the signal stays
internal to the C2N-DVP4DI, but it does not. Because there is no program in the
C2N-DVP4DI when it is a slave, the signal must be sent to the PRO2 for
interpretation and then re-routed back out to the C2N-DVP4DI. If this kind of traffic
is not desirable, then the PRO2 should contain a program and the C2N-DVP4DI
should be used as a master (standalone control system) with its own program, and the
programs should send any shared data via Ethernet ISC or XSIG. Then the signal
stays within the C2N-DVP4DI. The "To_Anywhere" has to go through an XSIG, if it
leaves the C2N-DVP4DI.
The advantages of this approach include simplicity, containment of all data within
the program and VT Pro-e project, very limited development time, and flexibility.
Equipment Required for Touch the PC
•
One C2N-DVP4DI Version 3.054 or higher
•
Two VGA Male cable to VGA Male cable
•
One RS-232 straight-through cable
•
Two DVI to RGB adapters supplied by Crestron
•
One 24 VDC 75 watt power supply for C2N-DVP4DI
Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A