Crestron C2N-DVP4DI Reference Manual page 93

Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A
2. Add the TPS-series touchpanel to the project. Connect the signal added in
the previous step to the serial input, which corresponds to the pad area as
defined in the touchpanel file. This allows Crestron Mouse type commands
to be used as a touch input for the C2N-DVP4DI.
VT Pro-e Sympodium Programming Considerations
Depending upon your configuration, some additional VT Pro-e programming may be
necessary.
Option 1 Implementation
No special VT Pro-e programming is needed.
Option 2 Implementation
Configure the Touch/Pad Area of the video window as follows:
1. Create a C2N-DVP4DI project.
2. Create a new page, and add a Video window.
3. Double click on the video window to bring up its properties.
4. Select the Design tab and enable Touch/Pad Area.
Design Tab in VT Pro-e
5. Select the Source tab, and select the appropriate DVI/VGA input being
used.
6. Compile and load the project.
Digital Video Processor
Digital Video Processor: C2N- DVP4DI • 89