Communicating Via Ethernet - Crestron C2N-DVP4DI Reference Manual

Digital Video Processor
26 • Contents
The IP address that is typed into the virtual touchpanel devices in the SIMPL
Windows program is the IP address of the CNX Gateway, not of the individual PCs
(running a web browser or Active CNX application). This is because individual PCs
may change, but the CNX Gateway normally does not.

Communicating via Ethernet

NOTE: Before performing this procedure, refer to "Establishing Communication
with the C2N-DVP4DI, TCP/IP Connection" in the C2N-DVP4DI Operations Guide
(Doc. 6112) for cabling instructions.
The Crestron Viewport may be used to communicate with the C2N-DVP4DI via
Ethernet. To connect the Viewport to the unit, perform the following procedure.
1. In the Viewport, select Setup | Communications Settings as shown to open
the "Port Settings" window.
Viewport Setup | Communications Settings
2. In the "Port Settings" window, select TCP/IP from the Connection Type
field as shown in the following illustration and select Fixed from the IP
Address field.
Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A