Ip Table Setup - Crestron C2N-DVP4DI Reference Manual

Crestron C2N-DVP4DI
Reference Guide – DOC. 6177A
SETTINGS FOR NETWORK WITH CRESTRON
If the C2N-DVP4DI is being placed on a corporate LAN or a LAN with other equipment
besides Crestron equipment, the IP address, IP Mask and Default Router (also known as the
Gateway) will be provided from an MIS Department of other network administrator.
Other Crestron IP control devices on this network would require that their IP Address, IP Mask
and Default Router also be obtained from the MIS department or other network administrator.
If the Network consists of only Crestron equipment, the following Private Address Ranges are
recommended for use.
Reference Guidelines
First Octet of Zero and 127 are reserved
Class A: First octet ranges from 1 to 128
Default Subnet Mask: 255.0.0.0
Class B: First two octet ranges from 128.1 to 191.254
Default Subnet Mask: 255.255.0.0
Class C: First three octet ranges from 192.0.1 to 233.255.254
Default Subnet Mask: 255.255.255.0
Class D: 224.0.0.0 to 239.255.255.254
(Not available for general use, reserved for multicast systems)
Class E: 240.0.0.0 to 255.255.255.254
(Not available for general use, reserved for multicast systems)
3. On the "Set Control System IP Address" window, click OK to set the
entered values.
4. The reboot window, as shown in the following graphic, opens. Click Yes to
reboot the C2N-DVP4DI and continue.
Reboot Window
5. You will receive a confirmation message that the IP information has been
setup. After the system reboots, select Function | Set Control System IP
Information, to view the IP Information.
NOTE: If an error message that the Viewport could not setup the IP information
appears, verify that the C2N-DVP4DI has been updated to the minimum operating
system required for Ethernet functionality. If the C2N-DVP4DI still cannot set the IP
information, contact Crestron customer service for assistance.

IP Table Setup

Ethernet devices that are addressed by the C2N-DVP4DI may have their IP
addresses set either in the SIMPL Windows program (default IP Table) or through
the Crestron Viewport using a PC. Just as each Cresnet device is assigned a Cresnet
NET ID, e.g. 03 through FE, to be used when programming, an Ethernet device is
assigned an IP ID that also may range from 03 through FE. Ultimately, each IP ID is
converted into an actual IP address through an IP table that exists inside the C2N-
DVP4DI.
Digital Video Processor
®
ONLY EQUIPMENT
Digital Video Processor: C2N- DVP4DI • 23