Using Tps-5000/6000 As A Touchscreen Mouse Connected Via Rs-232 - Crestron CNX-DVP4 Operation Manual

Crestron CNX-DVP4
Operations Guide – DOC. 8170A
6. Add a digital value of 6 to the Crestron Mouse symbol for the right button
mouse to work. This button is located on the bottom of the Smart mouse.
In Viewport:
NOTE: The following setting is only required when using a second pointing device
connected to the Touchscreen/Mouse port.
1. Set the touch input command to 1, by typing:
TOUCH <number corresponding to connected device>
and then press Enter.
2. Type: REBOOT and then press Enter.
Using TPS-5000/6000 as a Touchscreen Mouse
Connected via RS-232
Equipment required:
•
One CNX-DVP4 Version 3.017 or higher
•
One TPS-5000/6000 panel only with RGB card V1.017
•
One DVI to RGB adapter supplied by Crestron
•
One 24 VDC 75 watt power supply for CNX-DVP4
•
One RS-232 cable Crestron P/N STPK programming kit
•
One VGA Male cable to VGA Male cable
•
Cresnet cables
Software Required
•
SIMPL Windows Version 2.03.11 or higher
•
VT Pro-e Version 3.0.0.6 or higher
1. Connect the RS-232 cable from the touchpanel to the CNX-DVP4
touchscreen mouse serial port.
2. Set up the touchpanel serial port for RS-232 PORT FOR TOUCH OUT.
3. In VT Pro-e, create a page with full screen RGB window for the TPS-
5000/6000.
4. In RGB window property – select the Design tab and select Pad 1 or 2. For
Type, enter MOUSE and for Communication select SERIAL.
6. Send the project to the touchpanel.
7. From Viewport, set the CNX-DVP4 to Touch command # 8
8 – Crestron Tablet (TPS serial touchpanel)
NOTE: Each time a new touchscreen is connected to the Touchscreen/Mouse port,
and each time you switch between touchscreens, you must perform the
CALTOUCH command.
NOTE: CALTOUCH is not required when any type of mouse is connected.
NOTE: CALTOUCH may not always be necessary when "touch 8" is selected,
because it is a Crestron touchscreen.
Digital Video Processor
:
Digital Video Processor: CNX- DVP4 • 87