Connecting The C2N-Dvp4Di To The Sympodium - Crestron C2N-DVP4DI Reference Manual

Digital Video Processor
84 • Contents
Software Required
•
SIMPL Windows, version 2.04.11
•
VT Pro-e version 3.1.1.7
•
Viewport version 3.49
•
Smart board software (release date June, 2002 or later)
•
C2N-DVP4DI firmware version 3.054 or higher
Configuring the C2N-DVP4DI to Work with the Sympodium
1. From Viewport establish communication with the C2N-DVP4DI.
2. Ensure that the C2N-DVP4DI is in the master mode.
3. Load firmware Version 3.054 or higher into the C2N-DVP4DI.
4. Use the console command touch to set up the C2N-DVP4DI. Type touch
3, and press enter to select the Smart mode.
5. Type reboot and press enter to reboot the C2N-DVP4DI (you must
reboot for changes to take effect).
Configuring the Sympodium to Work with the C2N-DVP4DI
1. Load Smart Board software supplied by Smart into the computer to be
controlled by the Sympodium.
2. Verify that the Sympodium and PC are working properly together by
connecting the PC to the Sympodium – bypassing the Crestron system.

Connecting the C2N-DVP4DI to the Sympodium

1. Connect the C2N-DVP4DI to the Sympodium and computer as shown in
the diagram. It is very important to use CNSP-141 cables for the serial
connections. This is a 5-wire straight through cable, with only pins 2, 3, 5,
7, and 8 connected.
C2N-DVP4DI Connections
Smart Sympodium
DVI/RGB Input Serial Port
DVI/RGB Touchscreen
Output Mouse
DVI/RGB #4
Com 4
Input 1
VGA Output Com Port 1
PC w/Smart Board
Software
Crestron C2N-DVP4DI
Cresnet to
touchpanels
and other devices
as needed
C2N-DVP4DI
DVI/RGB
Inputs 2 - 4
DVI/RGB Signals RS-232 Interfaces
from up to 3 more up to 3 more
Computers or Computers or
Other Sources Other Sources
Ethernet
Connectivity
Available
if Needed
NET LAN
Video Inputs
Com 2 - 4
1 - 4
Up to 8
Video Signals
(no annotation)
Reference Guide – DOC. 6177A