Table of Contents
Advertisement
Digital Video Processor
C2N-DVP4DI Setup Checklist
Hardware Hookup
6 • Digital Video Processor: C2N-DVP4DI
Minimum Equipment Required for Setup
1. CNPWS-75 75W Power Supply (not included).
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to do
so could cause equipment damage or void the Crestron warranty.
2. Serial Mouse (9-pin)/Pointing Device (touch-screen sensitive screen overlay
connected to RS-232) for setup menu selection of the C2N-DVP4DI.
NOTE: The C2N-DVP4DI is supplied with a serial 9-pin mouse. The part number
for this mouse is OEMX-A0013-1.
3. Display device (projector, monitor, etc.).
4. Sources: video (composite, S-video, component), computer (RGB).
5. Video diagnostic program or pattern generator (installed on the PC).
6. Touchpanel (with RGB card) to setup the C2N-DVP4DI.
The following setup checklist permits a rapid setup of the C2N-DVP4DI. Details are
found on the appropriate page of this guide. Additional detailed information is
contained in the latest version of the C2N-DVP4DI Reference Guide (Doc. 6177),
available from the Crestron website (www.crestron.com).
NOTE: If this unit is to be mounted in a rack, refer to "Rack Mounting" on page 8.
Refer to page 9 for a hardware hookup diagram.
Connect the hardware in following order:
1. Connect video source(s): RGBHV, S-video, composite, and component
video sources to the inputs as specified by your SIMPL Windows and
Crestron VisionTools
2. Connect the RGB video output to a display device; for example, an LCD
panel or a projector.
3. Connect the Crestron supplied mouse and a touchscreen. Refer to "Pointing
Devices" on page 37, and to "Connecting a Pointing Device" in the latest
version of the C2N-DVP4DI Reference Guide (Doc. 6177), available from
the Crestron website (www.crestron.com).
4. Install compact flash. Refer to page 10.
5. Connect Cresnet power.
6. Connect RS-232 (DB9) Computer port for communication between the
C2N-DVP4DI and the PC (PC must have Viewport installed and open).
7. If the display device functions after power-up, go to the video output
procedure, step 11. If not, follow steps 8-10.
Crestron C2N-DVP4DI
®
Pro-e (VT Pro-e) projects.
Operations Guide – DOC. 6112
Advertisement
Table of Contents
