Table of Contents
Advertisement
3.2.4 Battery Connector
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Only
certified engineers should replace the on-board battery.
Dispose of used batteries according to instructions and local
regulations.
NOTE:
It is recommended to attach the RTC battery onto the system chassis
in which the gKINO-V/R1000 is installed.
CN Label:
CN Type:
CN Location:
CN Pinouts:
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.
Figure 3-5: Battery Connector Location
Page 22
BAT1
2-pin wafer, p=1.25 mm
See Figure 3-5
See Table 3-7
gKINO-V/R1000 SBC
Advertisement
Table of Contents
