Figure 20-3 Cisco Wan Manager Lan Connection Via Gateway Router To A Bpx Switch - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Configuring the LAN Port
Example: Configuring a Control Port (Gateway Router Example)
beta
Active IP Address:
IP Subnet Mask:
IP Service Port:
Default Gateway IP Address:
Maximum LAN Transmit Unit:
Ethernet Address:
Type
TCP
UDP
Telnet
This Command: cnflan
Enter IP Address:
Connect the Cisco WAN Manager workstation and the BPX switch to a LAN network. The LAN port
Step 3
on the BPX switch provides a DB-15 connector that can be connected to a Y-cable which in turn is
connected to an AUI.
To test that a LAN connection to the BPX switch LAN port is okay, for example, for a hostname of
Step 4
"sanfran" entered in the config.sv file, you would enter the following at the Cisco WAN Manager
workstation:
ping sanfran

Figure 20-3 Cisco WAN Manager LAN Connection via Gateway Router to a BPX Switch

193.287.107.1
Note: IP addresses are representative, only.
Step 5 An IP Relay address must be configured for each node. The following example shows an example of
using the cnfnwip command to configure the IP Relay address for a node.
Cisco BPX 8600 Series Installation and Configuration
20-8
TN YourID.1
State
UNAVAIL
READY
READY
Backbone
192.187.207.11
192.187.207.200
AUI
Cisco WAN Manager
Chapter 20
BPX 15 9.3 July 3 2000 02:16 PST
192.187.210.30
255.255.255.0
5120
192.187.207.1
1500
00.C0.43.00.00.20
192.187.207.1
Default
gateway
192.187.210.30
192.187.210.30
BCC-LM
Sanfran
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Configuring Network Management
H8124mod