Installing The Cisco Mds 9396V Switch; Preinstallation; Installing The Esd Grounding Strap - Cisco MDS 9396V Hardware Installation Manual

Installing the Cisco MDS 9396V Switch

This chapter describes how to install the Cisco MDS 9396V switch and its components.
•
•

Preinstallation

Note
Warning
Warning
Warning

Installing the ESD Grounding Strap

This section illustrates how to prepare yourself before removing the chassis from the sealed antistatic bag.
Preinstallation, on page 15
Installing the Switch, on page 25
Before you install, operate, or service the system, see the Regulatory Compliance and Safety Information for
the Cisco MDS 9000 Family for important safety information.
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
C H A P T E R
Cisco MDS 9396V Multilayer Fabric Switch Hardware Installation Guide
3
15