Aps K1 Command Precedence; Aps Command Summary; Table 26-6 K1 Switching Conditions - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

APS K1 Command Precedence

swwye
Detailed Card Display for BXM-155 in slot 2
Status:
Revision:
Serial Number
Fab Number
Queue Size
Support: 4 Pts, OC-3, FST,
Support: VT, ChStLv 2, VSIlvl 2
Support: APS (FW, HW1+1)
Support: OAMLp, TrfcGen
#Ch: 8128, PG[1] :8123
#Sched_Ch:16284
Last Command: dspcd 2
APS K1 Command Precedence
The possible conditions which may cause/prevent a switch are listed in Table 26-6. The list is arranged
starting from highest precedence and ending with lowest precedence. Refer to the Cisco WAN Switching
Command Reference for further description and information.

Table 26-6 K1 Switching Conditions

APS K1 Command Precedence
Lock out of Protection
Forced Switch
Signal Fail
Signal Degrade
Manual Switch
Wait To Restore
Reverse Request
Do not Revert
No Request

APS Command Summary

Commands to support APS are listed in Table 26-7, and defined in more detail in the Cisco WAN
Command Reference where you will find thorough information on each of these commands, as well as
other commands not listed here.
Cisco BPX 8600 Series Installation and Configuration
26-14
TN silves
Active
DDA
652774
28-2158-02
228300
VcShp
Chapter 26 Configuring SONET Automatic Protection System
BPX8620 9.3 March 9
Backcard Installed
Type: LM-BXM
Revision EW
Serial Number 1..1...
Supp: 4 Pts, OC-3, SMF, RedSlot:3
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
2000