Input Line Formats; Setting Up A Circuit Line; Table 19-2 Line Card Combinations - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Setting Up a Circuit Line

Table 19-1 Input Line Formats (continued)
Type Country Electrical Signal Format
E3 Europe Physical Layer Convergence Protocol per
and AT&T publication; ITU I-361 with HEC
others for E3
T3 USA Physical Layer Convergence Protocol per
Canada AT&T publication TA-TSY-00772 and
000773 for T3

Table 19-2 Line Card Combinations

Service
ATM
ATM
Frame Relay
Frame Relay
Frame Relay
High Speed Data IGX
High Speed Data IGX
Voice
Voice
Setting Up a Circuit Line
Frame relay, data, and voice connections require an active line. Before you can execute this procedure,
you must first up the card by using upcd.
To establish (or "up") an active line:
Cisco BPX 8600 Series Installation and Configuration
19-2
Ones Density Enforcement Multiplexing
HDB3
B3ZS+
Node Type Front Card
IGX UXM
IGX ALM/A
IGX UFM-4C, UFM-8C
IGX FRP-6, FRP-31/FRM-6,
FRM-31
IGX UFM-C
SDP/HDM
SDP/HDM
IGX UVM
IGX CDP/CVM
Chapter 19 Configuring Circuit Lines
ITU-T G.804, G.832
M13 mode
Back Card
BC-UAI
BC-UAI
BC-UAI-1T1
BC-UAI-1E1
BC-UAI-1OC3
BC-UAI-1T3
BC-UAI-1E3
UFI-8T1-DB15,
UFI-8E1-DB15,
UFI-8E1-BNC
FRI-T1, FRI-E1
UFI-8T1-DB15
UFI-8E1-DB15 or
UFI-8E1-BNC
SDI/RS-232
SDI/RS-422
SDI/RS-232
SDI/RS-422
BC-UVI-2T1EC
BC-UVI-2E1EC
BC-UVI-2J1EC
BC-T1
BC-E1
BC-J1
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001