Cisco BPX-BXM-155-8DX Installation And Configuration Manual page 427

Chapter 24 Configuring BXM Virtual Circuits
Example: BXM cnfport Command
ins-bpx6
Port:
Interface:
Type:
Speed:
Shift:
SIG Queue Depth:
Protocol:
SVC Channels:
SVC VPI Min:
SVC VPI Max:
SVC Bandwidth:
This Command: cnfport 13.1
NNI Cell Header Format? [N]:
Step 5 Configure the SVC Channels, SVC VPI Min, SVC VPI Max, and SVC Bandwidth as desired.
Next you need to configure the SVC Port Queue depth with the cnfportq <portnum> command shown
Step 6
in the following example.
Example: BXM cnfportq Command
ins-bpx6
Port:
Interface:
Type:
Speed:
SVC Queue Pool Size:
CBR Queue Depth:
CBR Queue CLP High Threshold: 80%
CBR Queue CLP Low Threshold:
CBR Queue EFCI Threshold:
VBR Queue Depth:
VBR Queue CLP High Threshold: 80%
VBR Queue CLP Low Threshold:
VBR Queue EFCI Threshold:
This Command: cnfportq 13.1
SVC Queue Pool Size [5000]:
Step 7 Configure the SVC Queue Pool Size parameter to a value greater than 0 (zero); the default is 0 and
needs to be changed for SVCs to operate.
Step 8 Partition the SVC resources for every BXM which is to support ATM SVCs in the BPX switch.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
TN SuperUser
13.1 [ACTIVE ]
LM-BXM
UNI
353208 (cps)
SHIFT ON HCF (Normal Operation)
640
NONE
TN SuperUser
13.1 [ACTIVE ]
LM-BXM
UNI
353208 (cps)
5000
600
60%
80%
5000
60%
80%
BPX 15 9.3 Sep. 24 2000 07:37 GMT
%Util Use:
1000
0
10
300000 (cps)
BPX 15 9.3 Sep. 24 2000 07:39 GMT
UBR/ABR Queue Depth:
UBR/ABR Queue CLP High Threshold:
UBR/ABR Queue CLP Low Threshold:
UBR/ABR Queue EFCI Threshold:
Cisco BPX 8600 Series Installation and Configuration
BXM SVC Resource Partitioning
Disabled
20000
80%
60%
30%
24-15