Virtual Trunk Uxm Commands; Virtual Trunk Bxm/Bni Commands; Compatibility Between Cards In Virtual Trunks; Table 25-10 Virtual Trunk Uxm Commands - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Cisco bpx-bxm-155-8dx: user guide
Table of Contents

Advertisement

Chapter 25
Configuring BXM Virtual Trunks
Table 25-9 Virtual Trunk Commands Common to BXM and UXM (IGX) (continued)
Command
prttrks
uptrk

Virtual Trunk UXM Commands

The commands listed in Table 25-10 are IGX (UXM) specific, or behave differently than their BPX
counterparts. Refer to the IGX 8400 Series documentation for further information about UXM virtual
trunk commands.

Table 25-10 Virtual Trunk UXM Commands

Command
clrtrkalm
clrphyslnalm
dspphysln
clrtrkstats

Virtual Trunk BXM/BNI Commands

The commands listed in Table 25-11 are BPX specific.

Table 25-11 Virtual Trunk Commands BXM/BNI

Command
clrtrkalm
cnfrsrc

Compatibility Between Cards in Virtual Trunks

Virtual trunking is supported on the BNI and BXM cards in the BPX, and on the UXM card in the IGX.
Note that firmware levels on these cards must be current.
While virtual trunking is supported on the BPX and IGX, BNI virtual trunks are not compatible with
BXM/UXM virtual trunks because the BXM and UXM cards both use the standard UNI and NNI cell
header formats across the virtual trunks (instead of the Strata-UNI cell format used on BNI virtual
trunks).
To use virtual trunking on a BXM or a UXM card, Release 9.2 software is required, and Release 9.2
BXM and UXM firmware. No hardware upgrade is required. The new firmware is backward
compatible.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Description
prints the active logical trunks
ups a trunk
Description
clears the statistical alarms for a logical trunk (affects logical trunk alarms
only)
clears statistical alarms for a physical trunk (IGX only)
displays physical line status (IGX only)
clear trunk stats (IGX only)
Description
clears the statistical alarms for a logical trunk [*]. (clears logical and physical
trunk alarms)
configure cell rate and number of conids (BXM only)
Compatibility Between Cards in Virtual Trunks
Cisco BPX 8600 Series Installation and Configuration
25-23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents