Figure 11-8 Ac Power Supply Installation - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 11 Installing the AC Shelf

Figure 11-8 AC Power Supply Installation

Plunger
Step 7 Align the power supply in the PS-A slots at the bottom of the Power Supply Tray and gently slide it in
part way (see Figure 11-8).
Step 8 Continue to slide the power supply in until it mates with the rear connector.
Step 9 When the power supply is completely seated in its connector, the pin plunger on the left side of the
supply will engage with a hole in the tray. If not, push firmly on the front edge until the power supply
assembly seats in the connector.
Screw the right-hand thumbscrew in finger tight.
Step 10
When a second power supply is provided, install it in the PS-B slot in the same manner after removing
Step 11
the Blank Panel from Slot B.
Rotate the power supply retainer up and tighten the center captive screw.
Step 12
Step 13 Install the Air Intake Grille. Press on the top center until the latch snaps into place.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Power supply
plunger hole
Power
supply
Power supply
thumb screw
Power supply
thumb screw
Retainer
captive
screw
Cisco BPX 8600 Series Installation and Configuration
Installing an AC Power Supply
Slot B empty if
non-redundant
Power supply
retainer
11-9