Routing Cables From Cards Through Cable Management Tray; Tray Raised With Cables In Place; Figure 12-8 Cables Routed Through Cable Management Tray In Lowered Position - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 12 Installing the T3/E3 Cable Management Tray

Routing Cables from Cards through Cable Management Tray

To route cables as shown in Figure 12-8:
Step 1 Verify that the cable management tray is in the lowered home position.
Step 2 Route cables from the cards through the cable clamps on the cable management tray.
Step 3 Secure the cable management tray to the cable tray brackets by inserting and tightening securing screw,
one to each bracket.

Figure 12-8 Cables Routed through Cable Management Tray in Lowered Position

Securing screw
(one each side)
To customer-supplied
interface panel

Tray Raised with Cables in Place

Figure 12-9 shows how to raise the cable management tray with cables in place, to provide access to
the Power Entry Modules (PEMs).
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Routing Cables from Cards through Cable Management Tray
Cisco BPX 8600 Series Installation and Configuration
Cable clamp
12-7