Table 26-7 Aps Commands - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 26 Configuring SONET Automatic Protection System

Table 26-7 APS Commands

Command
New Commands Added for Management of APS
cnfcdaps slot
addapsln slot1.port1 slot2.port2 protocol Adds APS.
delapsln slot.port
dspapsln
switchapsln slot.port (option 1...6, S)
cnfapsln slot.port
New Commands for Card Redundancy for APS 1+1
addcdred
dpscdred
delcdred
switchcdred
Commands modified for use with APS
cnfbkcd
dspalms
dspcd
dspsv3
dsplog
addyred
delyred
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Description
Sets APS options on the card.
Deletes APS.
Displays status of APS line pairs.
Controls the APS user switching interface.
Configures the APS parameters on a line.
Adds redundancy across two cards.
Display redundant cards.
Deletes redundancy configuration for cards.
Switches active and redundant cards.
Modified to APS options.
Added row for "APS Alarms" which lists Minor and
Major APS alarms.
Displays front and backcard APS attributes. For the front
card, displays that card supports APS 1+1 and APS 1:1.
For the back card, displays if backcard is a redundant
backcard, and if so, the slot number of the redundant
backcard. Also, displays APS mismatch conditions.
Modified to display APS alarms pending.
Displays APS alarms.
Modified to prevent invalid configurations when
combined with APS.
Modified to prevent invalid configurations when
combined with APS.
Cisco BPX 8600 Series Installation and Configuration
APS Command Summary
26-15