Table 21-7 Connection Parameter Descriptions - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

ATM Connection Configuration
Table 21-6 Connection Parameters with Default Settings and Ranges (continued)
PARAMETER WITH [DEFAULT SETTING]
CLP Lo/EPD [35/35]
EFCI [30/30]
For ATFR/ATFST [100/100]
RIF:
For ForeSight:
max[PCR/128, 10]
For ABR STD[128]
RDF:
For ForeSight [93]
For ABR STD [16]
Nrm[32], BXM only
FRTT[0], BXM only
TBE[1,048,320], BXM only
IBS[1/1]
Trunk cell routing restrict (Y/N) [Y]

Table 21-7 Connection Parameter Descriptions

Parameter
PCR
%Util
MCR
CDVT
FBTC (AAL5 Frame Basic
Traffic Control)
Cisco BPX 8600 Series Installation and Configuration
21-26
Description
Peak cell rate:
The cell rate which the source may never exceed
% Utilization; bandwidth allocation for: rt/nrt-VBR, CBR, UBR it's PCR*%Util, for
ABR it's MCR*%Util
Minimum Cell Rate:
A minimum cell rate committed for delivery by network
Cell Delay Variation Tolerance:
Controls time scale over which the PCR is policed
To enable the possibility of discarding the whole frame, not just one non-compliant
cell. This is used to set the Early Packet Discard bit at every node along a connection.
Note With the BXM, FBTC means packet discard on queueing only.
Chapter 21
BXM T3/E3, OC3 & OC12 RANGE
1 - 100%
1 - 100%
If ForeSight, then in absolute (0 - PCR)
n
If ABR then 2
(1 - 32768)
If ForeSight, then %
(0% - 100%)
n
If ABR then 2
(1 - 32768)
2 - 256 cells
0 - 16700 msec
0 - 1,048,320 cells
(different max range from TM spec. but limited by
firmware for CRM(4095 only) where CRM=TBE/Nrm
0 - 24000 cells
Y/N
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Configuring ATM Connections