Terminal Operation; Commands; Table 33-6 Dip Switch Settings; Table 33-7 Command Summary - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 33 AT3-6ME (T3 to T2) Interface Adapter

Terminal Operation

The system is designed to operate without a terminal. The terminal interface is designed for diagnostics
and maintenance purpose only. The terminal interface is always active and continuously displays the
user prompt. The terminal interface operating parameters are:
Electrical Interface:
DTE/DCE:
Speed:
Handshake:
Connector:
Upon power up:
•
•
•
•
•

Table 33-6 DIP Switch Settings

1
0/1

Commands

You enter commands after the user prompt to:
•
•
•
Table 33-7 lists available commands for use with the AT3-6ME terminal interface while Table 33-8
indicates the display format.

Table 33-7 Command Summary

Command
?
dspstat
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
RS232
DCE
9.6 Kbps
NON
Male DB9
The system goes through power up diagnostics:
The terminal displays the diagnostics sequence.
Upon successful self test the unit is available for operation.
The terminal displays the actual set up of the system represented by the DIP switches (see
Table 33-6).
If the configuration was overwritten through the TTY, the terminal will display the actual set up
that could be different then the dip switch setting.
2 3 4 5
0/1 0/1 0/1 0/1
Display the various error counters and alarms associated with the T2 line and the T3 port interface
Select the source of timing for the DSU
Enable and remove the remote loop
Parameters
6 7 8 9
0/1 0/1 0/1 0/1
Meaning
Help Menu.
Display status.
Cisco BPX 8600 Series Installation and Configuration
10 11 12 1
0/1 0/1 0/1 0/1
Operation
2
0/1
33-9