Table 15-7 V.34R Modem Configuration For Auto-Answer (Dial-In To Bpx) - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Connecting Dial-In and Dial-Out Modems
Step 2 Using the cnftermfunc command, set the terminal type to VT100/StrataView.
Step 3 To program the modem, temporarily attach a terminal to the modem using a straight through RS-232
cable (DTE to DCE). The modem EIA port will automatically match the 9600 bps setting of the
terminal.
Step 4 Enter the commands listed in Table 15-7 to set up the modem for proper operation.
Note Consult the manual supplied with your modem for specifics concerning the modem
configuration. Call Cisco Customer Service for latest modem configuration information.
Disconnect the terminal and the straight-through cable from the BPX CONTROL port.
Step 5
Step 6 Connect the modem to the BPX CONTROL port by using null-modem cables Figure 15-5. A null
modem cable is used because the connection is essentially a DCE to DCE rather than a DTE to DCE
connection.
Step 7 Ask Cisco Customer Service to assist in testing the operation of the modem setup.
Table 15-7 V.34R Modem Configuration for Auto-Answer
Step
1.
2
3.
4
5
6.
7.
8.
9.
10.
Cisco BPX 8600 Series Installation and Configuration
15-12
Command Function
AT & F Reset to factory default.
ATL1 Set modem loudness, modem speaker at low volume.
ATSØ=1 Enables Auto-Answer Mode on modem (answer on first ring).
AT\N3 Enables automatic MNP error correction.
AT%C Disables data compression.
AT\QØ Disables XON/XOFF flow control.
AT&S1 Sets DSR to "normal".
ATEØ Disables local character echo. Modem will not echo what you type.
ATQ1 Disables result codes. (Modem will appear "dead", will stop
responding "OK" to commands.)
AT&W Saves current configuration settings in non-volatile memory.
(Writes and stores to configuration location 1.)
Chapter 15 Connecting Temporary Terminal and Attaching Peripherals
(Dial-in to BPX)
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001