Table of Contents
Advertisement
Figure 10 - Reconfigure the pump-motor terminal-boxes (iH80/iH600 only)
3.8.3
Connect the electrical supply
This is an industrial (Class A) product as defined by EN61326. To ensure compliance with European
Electromagnetic Compatibility (EMC) requirements for EMC emissions, please note that it is not intended for use
in domestic buildings, or in properties directly connected to an electrical supply network which also supplies
domestic buildings.
Do not connect voltages greater than specified in
interface control may be damaged.
Notes:
1. Edwards recommend that the electrical supply be connected to a suitable isolator, which is easily
accessible for maintenance and clearly identified.
2. If you need further information on connecting the electrical supply, look it up on the Web using URL at
the start of manual, or contact your supplier or Edwards for advice.
© Edwards Limited 2008. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
1. Pump-motor terminal-box
2. Links
CAUTION
CAUTION
Table 5
to the control/interface connections. If you do, the
A590-00-880 Issue D
Page 21
Hide quick links:
Advertisement
Table of Contents
